Husqvarna 305 manual Trouble shooting, Trouble Shooting, Messages, Cause, Action

9.TROUBLE SHOOTING

9.Trouble shooting

In this chapter, we have listed a number of messages which may be shown in the display if there is a malfunction. There is a proposal as to the cause and steps to take for each message.

This chapter also presents some symptoms that can guide you if the mower does not work as expected.

More suggestions for steps to take in the event of malfunction or symptoms can be found on www.automower.com.

9.1 Messages

Below we have listed a number of messages which may be shown in the display of the Husqvarna Automower®. If the same message appears often: contact your dealer.

Message	Cause	Action
Left wheel motor	Grass or other object has wrapped	Check the drive wheel and remove
blocked	around the drive wheel.	the grass or other object.
Right wheel motor	Grass or other object has wrapped	Check the drive wheel and remove
blocked	around the drive wheel.	the grass or other object.
Blade disc blocked	Grass or other object has wrapped	Check the blade disc and remove the
	around the blade disc.	grass or other object.
	The blade disc lies in a pool of water.	Move the mower and if possible
		prevent the collection of water in the
		working area.
No loop signal	The transformer is not connected.	Check the wall socket connection and
		whether the miniature circuit-breaker
		has tripped. Check that the low
		voltage cable is connected to the
		charging station.
	The boundary wire is not connected	Check that the boundary wire
	to the charging station.	connector is fitted properly to the
		charging station. See 3.5 Connecting
		the boundary wire on page 27.
	Boundary wire broken.	Find out where the break is. Replace
		the damaged section of the loop with
		a new loop wire and splice using an
		original coupler.
	The boundary wire is laid in the wrong	Check that the boundary wire has
	direction around an island.	been laid according to the instructions
		in chapter 3 Installation.
	The connection between Automower®	Park Automower® in the charging
	and the charging station has been	station and generate a new loop
	lost.	signal via Security -> New loop signal
		(3-3).
	Disturbances from metal objects	Try moving the boundary wire.
	(fences, reinforcement steel) or
	buried cables close by.

English - 59