3.INSTALLATION
6.Connect the guide wire to the boundary wire with
the help of a solderless coupler:
Insert the boundary wire in each of the holes in the coupler. Insert the guide wire in the centre hole in the coupler. Check that the wires are fully inserted into the coupler so that the ends are visible through the transparent area on the other side of the coupler.
Use pliers to completely compress the button on the coupler.
It does not matter which holes are used to connect each wire.
7.Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies depending on how the working area appears. It is therefore recommended to test the installation with the help of the function Test IN
IMPORTANT INFORMATION
The guide wire may not cross the boundary wire, for instance a boundary wire that is laid out to an island.
3.7 Checking the installation
Check the loop signal by inspecting the indicator lamp on the charging station.
• Steady green light = good signals.
• Flashing blue light = interruption in the boundary wire, no signal.
• Flashing yellow light = interruption in the guide wire, no guide signal.
• Flashing red light = interruption in the charging station's antenna plate, no remote signal available. The fault should be rectified by an authorized dealer.
•Steady blue light = weak signal. This may depend on the boundary wire being over 250 m in length or that the wire is damaged. If the mower still works, this is not a problem.
•Steady red light = fault in a circuit board in the charging station. The fault should be rectified by an authorized dealer.
See 9.2 Indicator lamp in the charging station on page 62 if the lamp does not indicate a solid green light.
English - 31
