Husqvarna 305 manual Drive past wire, Change PIN code, Security levels, Function, Medium, High

6. MENU FUNCTIONS

State a distance that easily exceeds the true distance. The maximum distance that can be stated is

500 metres. Place Automower® in the charging station and select Test OUT (2-3-2). The mower will immediately leave the charging station. The distance will be shown on the display, stated in metres, as the mower runs. Stop the mower at the required position and note the distance. Enter the number of metres shown in Distance for the area in question.

Drive past wire (2-4)

The front of the mower always passes the boundary wire by a specific distance before the mower turns. The default distance is 25 cm, but this can be changed if required.The minimum value is 25 cm and the maximum value is 30 cm.

Now specify the number of centimetres you want the mower to pass the boundary wire and press OK.

6.5 Security (3)
Through this selection, settings relating to security
	Timer
and the connection between the mower and the
charging station can be made.
	Installation
Change PIN code (3-1)
Enter the new PIN code and press OK. Enter the	Security
same code again and confirm by pressing OK. When
the PIN code is changed, a message stating that the	Settings
PIN code has been changed appears in the display
momentarily.
Make a note of the new PIN code on the designated
line in Memo on page 4.

Change PIN code

Security level

New loop signal

Security levels (3-2)

There are three security levels to choose from: low, medium and high. Low and medium security prohibits access to Automower® if the PIN code is unknown. High security also includes a warning that sounds if the correct PIN code is not entered after a designated time period.

Chainge PIN code

Security level

New loop signal

Low

Medium

High

Function	Low	Medium	High
Time lock	X	X	X
PIN request		X	X
Alarm			X

English - 47