2
To install bagger components to tractor
1
1. | Discharge Chute | 2 |
|
2. | 3/8 Nut |
| |
|
| ||
3. | Flat Washer | 3 | 0 |
|
|
| 2277 |
•Remove discharge chute from rear of tractor. Unhook the two (2) straps and pull chute out and away from tractor.
•Remove the two (2) 3/8 nuts and fl at washers from the bolts at the tractor back plate.
|
|
| 2 |
|
1. | Support Bracket | 4 |
|
|
|
|
| ||
2. | Clevis Pin 10 x 17mm | 1 |
| |
3. | Retainer Spring |
| 5 | 3 |
4. | Clevis Pin 10 x 50mm |
| ||
| 3 | |||
5. | 10,3mm (13/32") flat |
| ||
| 1 | |||
| washer |
|
|
0 2813
•Install the two upper support brackets through the back plate and to the chassis, install the clevis pin 10x17mm and secure with retainer spring.
•Assemble both support brackets to the outside of the baggger support tube install the clevis pin 10x50mm and secure with retainer spring.
|
| 3 |
|
| 2 |
|
| 1 |
1. | 3/8 Lock nut | 02330 |
2. | Flat Washer |
|
3. | Support Tube |
|
1.Hook
2.Discharge Chute
3.Back plate slot
2 1
02306
•Using the nuts and fl at washers removed from tractor back plate, install the bagger support tube to the back plate as shown. Tighten securely.
3
•Replace discharge chute into rear opening of tractor. Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate. This will allow the discharge chute to fl oat with the mower deck when moving on uneven terrain.
24