Rider
Operator´s manual
English
Svenska –
IMPORTANT INFORMATION
CONTENTS Operator’s Manual for Rider
Safe operation practices for ride-onmowers
1. Safety rules for USA
I.General operation
II.Slope operation
Travel and transport on public roads
IV. Service
Towing
Intended use
Dear customer
INTRODUCTION
Travel and transport on public roads
Towing
Good service
Serial number
INTRODUCTION
EXPLANATION OF SYMBOLS
EXPLANATION OF SYMBOLS
Placards
English
8009-442
General use
SAFETY INSTRUCTIONS
Clear the area of objects before mowing
Never carry passengers
Personal protective equipment
Keep children away from the area to be mowed
SAFETY INSTRUCTIONS
moving parts
Driving on slopes
Be especially careful when driving on slopes
Proceed as follows
Mow upwards and downwards on slopes, not sideways
Children
Maintenance
Never allow children to operate the machine
Never fill the fuel tank indoors
Do not smoke when carrying out maintenance
Risk of burn injuries if touched
SAFETY INSTRUCTIONS
Never run the machine in an enclosed area
Transport
machine
SAFETY INSTRUCTIONS
PRESENTATION
Presentation
Location of the controls
Speed limiter
Throttle and Choke lever
Parking brake
PRESENTATION
Lift lever for cutting unit
Cutting unit
Lifting of the cutting unit transport position
Lowering of the cutting unit cutting position
Seat
Lever for adjustment of cutting height
Fuelling
PRESENTATION
Before starting
DRIVING
Starting the engine
Cold engine
Warm engine
DRIVING
IMPORTANT INFORMATION
DRIVING
Driving the machine
Mowing pattern
Cutting tips
DRIVING
IMPORTANT INFORMATION
Stopping the engine
Release lever
DRIVING
Maintenance schedule
MAINTENANCE
Maintenance interval
Maintenance
Engine hood
Removal of the machine hoods
Front hood
Right-handfender
Checking and adjustment of the steering wires
Adjusting the brake
MAINTENANCE
Adjusting the throttle wire
Replacement of the fuel filter
MAINTENANCE
Never use compressed air to clean the air filters
Service of the air filter
MAINTENANCE
IMPORTANT INFORMATION
Procedures on contact with acid
Battery
Ignition system
External: Rinse well with plenty of water
MAINTENANCE
Inspecting the safety system
Checking the tyre pressure
Main fuse
Check the engine’s cooling air intake
Air intake grille
Fitting the cutting unit
Observe caution to avoid trapping your hand
MAINTENANCE
MAINTENANCE
Removing the cutting unit
2. Place the Rider on a flat surface
MAINTENANCE
Adjusting the parallelism of the cutting unit
Checking the cutting unit’s parallelism
MAINTENANCE
Replacing the cutting unit belt
MAINTENANCE
IMPORTANT INFORMATION
Placing in service position
Service position for cutting unit
MAINTENANCE
36 – English
7. Engage the strut in the holder
MAINTENANCE
Restoring from service position
MAINTENANCE
Observe caution to avoid trapping your hand
Combi
Checking the blades
MAINTENANCE
IMPORTANT INFORMATION
Replacing the break-pin
Service position
Removal of BioClip plug Combi
Removal of BioClip plug
Check the engine’s oil level
LUBRICATION
Changing the oil
The dip stick must not be screwed down
Change of oil filter
Lubricating the belt adjuster
Check the transmission’s oil level
General lubrication
TROUBLE SHOOTING SCHEDULE
Problem
Procedure
STORAGE
Service
Winter storage
Cover
Dimensions
TECHNICAL DATA
Rider
Engine
Work done
SERVICE JOURNAL
Date, mileage, stamp, sign
46 – English
Work done
SERVICE JOURNAL
Date, mileage, stamp, sign
English –
SERVICE JOURNAL
´+H-¶5c¨
Work done
Date, mileage, stamp, sign
Page
114 01
´+H-¶5c¨ 2002W39