Removing the cutting unit | Husqvarna Rider 155 guide

MAINTENANCE

6.Move the support wheels to their parking position.

7.Fit the front cover.

WARNING!

Wear protective glasses when installing or removing the cutting unit. The collet spring which tensions up the belt can go off and cause personal injury.

8. Secure the collet spring.

Removing the cutting unit

1.Carry out points 1-9 to put the cutting unit in the service position, see “Service position for the cutting unit”.

2.Remove the bolt (3) and lift off the cutting unit.

8009-439

8009-440

2

1

3

6017-021

32 – English

Image 34

Husqvarna Rider 155 manual Removing the cutting unit

Contents

Rider English Svenska Contents II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. Children Towing IV. ServiceTravel and transport on public roads Intended use Travel and transport on public roads IntroductionDear customer Towing Good service Serial number Explanation of Symbols Starting Instruction Placards Safety Instructions General use Keep children away from the area to be mowed Driving on slopes Proceed as follows Maintenance Children Do not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unit Seat Lever for adjustment of cutting heightFuelling Starting the engine DrivingBefore starting Cold engine Warm engine Driving the machine Cutting tips Stopping the engine Release lever Daily Maintenance interval MaintenanceMaintenance schedule Hours Front hood Removal of the machine hoodsEngine hood Right-hand fender Adjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Adjusting the throttle wire Replacement of the fuel filter Service of the air filter Ignition system BatteryFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your hand Removing the cutting unit 6017-216 Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelism Replacing the cutting unit belt Service position for cutting unit Placing in service position 6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Replacing the break-pin Removal of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Dip stick must not be screwed down Check the transmission’s oil level Lubricating the belt adjusterChange of oil filter General lubrication Trouble Shooting Schedule Problem Procedure Winter storage ServiceStorage Cover Technical Data Service Journal Work done Date, mileage, stamp, sign Service Journal ´+H-¶5c¨ English 114 01