English
Rider
Operator´s manual
Svenska –
IMPORTANT INFORMATION
CONTENTS Operator’s Manual for Rider
II.Slope operation
1. Safety rules for USA
Safe operation practices for ride-onmowers
I.General operation
Intended use
IV. Service
Travel and transport on public roads
Towing
Towing
INTRODUCTION
Dear customer
Travel and transport on public roads
INTRODUCTION
Good service
Serial number
EXPLANATION OF SYMBOLS
8009-442
Placards
EXPLANATION OF SYMBOLS
English
Never carry passengers
SAFETY INSTRUCTIONS
General use
Clear the area of objects before mowing
moving parts
Keep children away from the area to be mowed
Personal protective equipment
SAFETY INSTRUCTIONS
Mow upwards and downwards on slopes, not sideways
Be especially careful when driving on slopes
Driving on slopes
Proceed as follows
Never fill the fuel tank indoors
Maintenance
Children
Never allow children to operate the machine
SAFETY INSTRUCTIONS
Do not smoke when carrying out maintenance
Risk of burn injuries if touched
SAFETY INSTRUCTIONS
Transport
Never run the machine in an enclosed area
machine
Location of the controls
PRESENTATION
Presentation
PRESENTATION
Throttle and Choke lever
Speed limiter
Parking brake
Lowering of the cutting unit cutting position
Cutting unit
Lift lever for cutting unit
Lifting of the cutting unit transport position
PRESENTATION
Lever for adjustment of cutting height
Seat
Fuelling
Cold engine
DRIVING
Before starting
Starting the engine
IMPORTANT INFORMATION
Warm engine
DRIVING
DRIVING
Driving the machine
IMPORTANT INFORMATION
Cutting tips
Mowing pattern
DRIVING
DRIVING
Stopping the engine
Release lever
Maintenance
MAINTENANCE
Maintenance schedule
Maintenance interval
Right-handfender
Removal of the machine hoods
Engine hood
Front hood
MAINTENANCE
Checking and adjustment of the steering wires
Adjusting the brake
MAINTENANCE
Adjusting the throttle wire
Replacement of the fuel filter
IMPORTANT INFORMATION
Service of the air filter
Never use compressed air to clean the air filters
MAINTENANCE
External: Rinse well with plenty of water
Battery
Procedures on contact with acid
Ignition system
MAINTENANCE
Inspecting the safety system
Air intake grille
Main fuse
Checking the tyre pressure
Check the engine’s cooling air intake
MAINTENANCE
Fitting the cutting unit
Observe caution to avoid trapping your hand
MAINTENANCE
Removing the cutting unit
2. Place the Rider on a flat surface
MAINTENANCE
MAINTENANCE
Adjusting the parallelism of the cutting unit
Checking the cutting unit’s parallelism
IMPORTANT INFORMATION
Replacing the cutting unit belt
MAINTENANCE
36 – English
Service position for cutting unit
Placing in service position
MAINTENANCE
7. Engage the strut in the holder
MAINTENANCE
Observe caution to avoid trapping your hand
Restoring from service position
MAINTENANCE
IMPORTANT INFORMATION
Checking the blades
Combi
MAINTENANCE
Removal of BioClip plug
Service position
Replacing the break-pin
Removal of BioClip plug Combi
The dip stick must not be screwed down
LUBRICATION
Check the engine’s oil level
Changing the oil
General lubrication
Lubricating the belt adjuster
Change of oil filter
Check the transmission’s oil level
Procedure
TROUBLE SHOOTING SCHEDULE
Problem
Cover
Service
STORAGE
Winter storage
Engine
TECHNICAL DATA
Dimensions
Rider
46 – English
SERVICE JOURNAL
Work done
Date, mileage, stamp, sign
English –
SERVICE JOURNAL
Work done
Date, mileage, stamp, sign
Date, mileage, stamp, sign
´+H-¶5c¨
SERVICE JOURNAL
Work done
Page
114 01
´+H-¶5c¨ 2002W39