Husqvarna Rider 155 Main fuse, Checking the tyre pressure, Check the engine’s cooling air intake

MAINTENANCE

Main fuse

The fuse is located in a loose holder under the battery case cover, in front of the battery. Type: Flat-blade U-link, 15 A.

Do not use any other type of fuse when replacing. A blown fuse indicates that the U-link has burnt off. Pull the fuse out of the holder when replacing.

The fuse is used to protect the electrical system. If it blows again shortly after replacing this is due to a short circuit, which must be rectified before the machine is used again.

Checking the tyre pressure

The tyre pressure should be 60 kPa (0.6 kp/cm2/8.5 PSI) all round.

To improve driving, the pressure on the rear tyres can be reduced to 40 kPa (0.4 kp/cm2/5.6 PSI).

The maximum tyre pressure is 100 kPa (1.0 kp/cm2/14 PSI).

IMPORTANT INFORMATION

Different tyre pressures on the front tyres will result in the blades cutting the grass at different heights.

8009-370

6008-030

Check the engine’s cooling air intake

Clean the air intake grille in the engine cover behind the driver’s seat.

Fold open the engine cover.

Check that the cooling intake is free from leaves, grass and dirt.

Check the air duct, located on the inside of the engine cover, ensure it is clean and does not rub against the cooling air intake.

If the cooling intake is blocked this will interfere with the cooling of the engine, which can damage the engine.

WARNING!

The cooling air intake rotates when the engine is running. Mind your fingers.

8009-431

Air intake grille

8009-470

Cooling air intake

30 – English