English
Rider
Operator´s manual
Svenska –
CONTENTS Operator’s Manual for Rider
IMPORTANT INFORMATION
I.General operation
1. Safety rules for USA
Safe operation practices for ride-onmowers
II.Slope operation
Towing
IV. Service
Travel and transport on public roads
Intended use
Travel and transport on public roads
INTRODUCTION
Dear customer
Towing
INTRODUCTION
Good service
Serial number
EXPLANATION OF SYMBOLS
English
Placards
EXPLANATION OF SYMBOLS
8009-442
Clear the area of objects before mowing
SAFETY INSTRUCTIONS
General use
Never carry passengers
SAFETY INSTRUCTIONS
Keep children away from the area to be mowed
Personal protective equipment
moving parts
Proceed as follows
Be especially careful when driving on slopes
Driving on slopes
Mow upwards and downwards on slopes, not sideways
Never allow children to operate the machine
Maintenance
Children
Never fill the fuel tank indoors
SAFETY INSTRUCTIONS
Do not smoke when carrying out maintenance
Risk of burn injuries if touched
machine
Transport
Never run the machine in an enclosed area
SAFETY INSTRUCTIONS
Location of the controls
PRESENTATION
Presentation
Parking brake
Throttle and Choke lever
Speed limiter
PRESENTATION
Lifting of the cutting unit transport position
Cutting unit
Lift lever for cutting unit
Lowering of the cutting unit cutting position
Fuelling
Lever for adjustment of cutting height
Seat
PRESENTATION
Starting the engine
DRIVING
Before starting
Cold engine
IMPORTANT INFORMATION
Warm engine
DRIVING
Driving the machine
DRIVING
DRIVING
Cutting tips
Mowing pattern
IMPORTANT INFORMATION
DRIVING
Stopping the engine
Release lever
Maintenance interval
MAINTENANCE
Maintenance schedule
Maintenance
Front hood
Removal of the machine hoods
Engine hood
Right-handfender
MAINTENANCE
Checking and adjustment of the steering wires
Adjusting the brake
MAINTENANCE
Adjusting the throttle wire
Replacement of the fuel filter
MAINTENANCE
Service of the air filter
Never use compressed air to clean the air filters
IMPORTANT INFORMATION
Ignition system
Battery
Procedures on contact with acid
External: Rinse well with plenty of water
Inspecting the safety system
MAINTENANCE
Check the engine’s cooling air intake
Main fuse
Checking the tyre pressure
Air intake grille
MAINTENANCE
Fitting the cutting unit
Observe caution to avoid trapping your hand
Removing the cutting unit
MAINTENANCE
MAINTENANCE
2. Place the Rider on a flat surface
MAINTENANCE
Adjusting the parallelism of the cutting unit
Checking the cutting unit’s parallelism
IMPORTANT INFORMATION
Replacing the cutting unit belt
MAINTENANCE
MAINTENANCE
Service position for cutting unit
Placing in service position
36 – English
MAINTENANCE
7. Engage the strut in the holder
Observe caution to avoid trapping your hand
Restoring from service position
MAINTENANCE
MAINTENANCE
Checking the blades
Combi
IMPORTANT INFORMATION
Removal of BioClip plug Combi
Service position
Replacing the break-pin
Removal of BioClip plug
Changing the oil
LUBRICATION
Check the engine’s oil level
The dip stick must not be screwed down
Check the transmission’s oil level
Lubricating the belt adjuster
Change of oil filter
General lubrication
Procedure
TROUBLE SHOOTING SCHEDULE
Problem
Winter storage
Service
STORAGE
Cover
Rider
TECHNICAL DATA
Dimensions
Engine
Date, mileage, stamp, sign
SERVICE JOURNAL
Work done
46 – English
Date, mileage, stamp, sign
SERVICE JOURNAL
Work done
English –
Work done
´+H-¶5c¨
SERVICE JOURNAL
Date, mileage, stamp, sign
Page
´+H-¶5c¨ 2002W39
114 01