Rider
Operator´s manual
English
Svenska –
CONTENTS Operator’s Manual for Rider
IMPORTANT INFORMATION
1. Safety rules for USA
Safe operation practices for ride-onmowers
I.General operation
II.Slope operation
IV. Service
Travel and transport on public roads
Towing
Intended use
INTRODUCTION
Dear customer
Travel and transport on public roads
Towing
Good service
Serial number
INTRODUCTION
EXPLANATION OF SYMBOLS
Placards
EXPLANATION OF SYMBOLS
English
8009-442
SAFETY INSTRUCTIONS
General use
Clear the area of objects before mowing
Never carry passengers
Keep children away from the area to be mowed
Personal protective equipment
SAFETY INSTRUCTIONS
moving parts
Be especially careful when driving on slopes
Driving on slopes
Proceed as follows
Mow upwards and downwards on slopes, not sideways
Maintenance
Children
Never allow children to operate the machine
Never fill the fuel tank indoors
Do not smoke when carrying out maintenance
Risk of burn injuries if touched
SAFETY INSTRUCTIONS
Transport
Never run the machine in an enclosed area
machine
SAFETY INSTRUCTIONS
PRESENTATION
Presentation
Location of the controls
Throttle and Choke lever
Speed limiter
Parking brake
PRESENTATION
Cutting unit
Lift lever for cutting unit
Lifting of the cutting unit transport position
Lowering of the cutting unit cutting position
Lever for adjustment of cutting height
Seat
Fuelling
PRESENTATION
DRIVING
Before starting
Starting the engine
Cold engine
Warm engine
DRIVING
IMPORTANT INFORMATION
Driving the machine
DRIVING
Cutting tips
Mowing pattern
DRIVING
IMPORTANT INFORMATION
Stopping the engine
Release lever
DRIVING
MAINTENANCE
Maintenance schedule
Maintenance interval
Maintenance
Removal of the machine hoods
Engine hood
Front hood
Right-handfender
Checking and adjustment of the steering wires
Adjusting the brake
MAINTENANCE
Adjusting the throttle wire
Replacement of the fuel filter
MAINTENANCE
Service of the air filter
Never use compressed air to clean the air filters
MAINTENANCE
IMPORTANT INFORMATION
Battery
Procedures on contact with acid
Ignition system
External: Rinse well with plenty of water
Inspecting the safety system
MAINTENANCE
Main fuse
Checking the tyre pressure
Check the engine’s cooling air intake
Air intake grille
Fitting the cutting unit
Observe caution to avoid trapping your hand
MAINTENANCE
Removing the cutting unit
MAINTENANCE
MAINTENANCE
2. Place the Rider on a flat surface
Adjusting the parallelism of the cutting unit
Checking the cutting unit’s parallelism
MAINTENANCE
Replacing the cutting unit belt
MAINTENANCE
IMPORTANT INFORMATION
Service position for cutting unit
Placing in service position
MAINTENANCE
36 – English
MAINTENANCE
7. Engage the strut in the holder
Restoring from service position
MAINTENANCE
Observe caution to avoid trapping your hand
Checking the blades
Combi
MAINTENANCE
IMPORTANT INFORMATION
Service position
Replacing the break-pin
Removal of BioClip plug Combi
Removal of BioClip plug
LUBRICATION
Check the engine’s oil level
Changing the oil
The dip stick must not be screwed down
Lubricating the belt adjuster
Change of oil filter
Check the transmission’s oil level
General lubrication
TROUBLE SHOOTING SCHEDULE
Problem
Procedure
Service
STORAGE
Winter storage
Cover
TECHNICAL DATA
Dimensions
Rider
Engine
SERVICE JOURNAL
Work done
Date, mileage, stamp, sign
46 – English
SERVICE JOURNAL
Work done
Date, mileage, stamp, sign
English –
´+H-¶5c¨
SERVICE JOURNAL
Work done
Date, mileage, stamp, sign
Page
´+H-¶5c¨ 2002W39
114 01