sary, without notification. If a change has been made to your machine which is not reflected in this parts manual, see your Hustler dealer for current information and parts.
Hardware Description Codes & Abbreviations
The following codes are used throughout this parts manual. Refer to this list when ordering parts.
ABBREVIATIONDESCRIPTION
CB | Carriage Bolt |
CE | Clevis Pin |
CP | Cotter Pin |
CS | Cap Screw |
CW | Cup Washer |
FDRW | Fender Washer |
FW | Flat Washer |
HX | Hex Head |
LW | Lock Washer |
MB | Machine Bushing |
MS | Machine Screw |
NT | Nut |
SC | Self Tapping Cap Screw |
SH | Socket Head |
SB | Shoulder Bolt |
SS | Set Screw |
OD | Outside Diameter |
ID | Inside Diameter |
Standard Torques
The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener
SIZE |
| NM | SIZE | NM | |
.250 | 8.2 | 11.1 | M3 | 1 | 1.3 |
.312 | 17 | 23 | M4 | 2.2 | 3 |
.375 | 30 | 40 | M5 | 4.5 | 6.1 |
.438 | 48 | 65 | M6 | 7.7 | 10.4 |
.500 | 73 | 99 | M8 | 18.5 | 25 |
.562 | 105 | 143 | M10 | 37 | 50 |
.625 | 145 | 200 | M12 | 64 | 87 |
.750 | 260 | 350 | M16 | 160 | 215 |
.875 | 420 | 565 | M20 | 320 | 435 |
1.00 | 625 | 850 | M24 | 555 | 750 |
NOTE:
Loctite® 592 to be used on all pipe threads.
Lubricate all grease zerks.
302620 8/06 |
