PCMCIA Subsystem
The | system board has two PCMCIA (Personal Computer Memory |
Card | International Association) slots that support the following types |
of | PC Card: |
Ÿ 16 bit PC Card
Ÿ32 bit PC Card
However, x.xV, y.yV, DMA, and ZV are not supported.
The maximum current allowable for both slots at the same time is:
Ÿ | 1.0 | A | at | 5 V | dc |
Ÿ | 0.8 | A | at | 3.3 | V dc |
Ÿ0.1 A at 12 V dc
|
|
|
|
|
|
|
|
| 2 | isUnitused as the PC card |
|
|
| |||||||
The PCI1250 |
|
|
| |||||||||||||||||
controller |
| in | the | system | unit. The | available | interrupt | levels | are | IRQ | ||||||||||
3, | 4, | 5, | 7, | 9, 10, | 11, | 14, | and | 15. |
|
|
|
|
|
|
|
|
| |||
The system unit resumes operation from suspend mode when it |
|
| ||||||||||||||||||
receives the ‘RI_OUT’ | signal. The | Type | I | and Type II PC cards can | ||||||||||||||||
be | installed | into | either | the | upper | or | the | lower slot, or into both slots | ||||||||||||
at | the | same | time. The Type III | PC | card, | however, | must | be | installed | |||||||||||
only in the lower slot. The Type | II | PC | card | cannot | be | used | in | the | ||||||||||||
upper | slot | when | a | Type | III | PC | card |
| is used. |
|
|
|
|
| ||||||
The PCMCIA slots are designed | according | to | the | PC Card | standard |
| ||||||||||||||
made | in | February | 1995. |
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Manufactured by Texas Instruments corporation.
Subsystems