IBM ILV200, ILC200 manual Connecting a computer, To connect To disconnect

DANGER

Electrical current from power, telephone, and communication cables is hazardous.

To avoid a shock hazard:

—Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.

—Connect all power cords to a properly wired and grounded electrical outlet.

—Connect to properly wired outlets any equipment that will be attached to this product.

—When possible, use one hand only to connect or disconnect signal cables.

—Never turn on any equipment when there is evidence of fire, water, or structural damage.

—Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless instructed otherwise in the installation and configuration procedures.

—Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this product or attached devices.

To connect:		To disconnect:
1.	Turn everything OFF.	1.	Turn everything OFF.
2.	First attach all cables to devices.	2.	First, remove power cords from outlet.
3.	Attach signal cables to connectors.	3.	Remove signal cables from connectors.
4.	Attach power cords to outlet.	4.	Remove all cables from devices.
5.	Turn device ON.

Connecting a computer

The projector comes with an M1-DA analog computer cable. If your computer has a digital output, you can use the optional M1-DA digital computer cable, sold separately. See Appendix A for ordering accessories.

1.Plug the end of the M1-DA analog computer cable (marked A) into the connector marked AD on the projector.

2.Plug the end of the M1-DA analog computer cable into the video connector on your computer.

1-6iLV200/iLC200 IBM Data/Video Projector: User’s Guide