IBM M110 4.1.5 Host Name

Mode: Mode Selection

(Local, LPR)

Destination Host: Selection from host table

Queue Name: Select the host computer and the

queue name of the printer you want to use in

that host

CAUTION: You must make sure the SpotLine terminal has been given

permission to use this printer.

4.1.5 Host Name

Enter the symbolic name of any host computers to which you will

connect, as well as their IP address. You can then connect just by using

the Host Name when the terminal or session starts up.

Mode

Local

LPR

Destination

Host

None

USA-0212-000003

Host Table

Host Name Internet Address

Enter: Save Arrows/Tab: Next Field F2: Copy F3: Paste

F4: Clear Field Esc: Cancel

Contents

Main SpotLine M110 User Guide Page SpotLine M110 User Guide Table of Contents Page 1.0 Introduction Page 1.0 Specifications Page 2.0 Getting Started 3.1 Installation 3.2 Setup 3.0 Usage 4.1 Configuration Setup 4.1.1 User Environment Page Page 4.1.2 Port Configuration Page Page 4.1.3 Sessions Page Page 4.1.4 Network Parameters Page Page Page 4.1.5 Host Name 4.1.8 Exit without Saving 4.2 Reverse Telnet Page 4.3 Remote TTY for Unix Systems Page 4.4 Reversal of the LEDs for Num. Lock and Caps Lock 4.5 Purge the Printer Buffer 4.6 Function Key 4.6.1 Function Key Reset 4.6.2 Programming function keys (F1- F24) Page 4.7 Multiscreen Session Switching 4.7.1 How to declare SCO mscreen for SpotLine Terminals 4.8 Telnet Session Page 4.0 Software Configuration 5.1 SCO XENIX/Unix 5.1.1 Use as a Telnet Session LAN Terminal Page 5.1.3 Use as a Serial Terminal 5.2 Use with IBMs AIX Unix 5.2.1 Use as a Serial AIX Terminal Device 5.2.2 Use as a Telnet terminal Page 5.3 Other Unix Versions 5.3.1 Use as a Serial Terminal 5.4 Use with Other Operating Systems 5.0 Cabling 6.1 Terminal to Host Cabling 6.2 Serial Printer Cabling 6.0 Emulation 7.1 General 7.2 Keyboard Control Characters Page 7.3 Screen Control Parameters Page Page 7.5 Additional ESC Commands Page 7.0 Warranty