Replacing the system board access cover
After you have finished installing cards on the printer system board, you must replace the system board access cover.
1Align the slots at the top of the access cover with the screws near the top of the printer.
2Slide the cover up under the top cover lip as far as it will go, and then tighten the screws at the top of the cover.
3Insert and tighten the four screws to the bottom of the cover.
If you installed a firmware card in your printer, see the following section for information about applying the Option Added label.
Applying the Option Added label
The Option Added label alerts service personnel that additional options have been installed in your printer.
To apply the label:
1Remove the backing from the label.
2Place the label next to the printer model and serial number label.
Install memory, firmware, or option cards
25
