|
|
|
|
| 9 |
|
| TROUBLESHOOTING | |||
|
|
|
|
| |
PROBLEM | POSSIBLE CAUSE |
| SOLUTION | REF. | |
No power comes ON. | • Bad connection to the power supply. |
| • Check the connection to the transceiver. | p. 19 | |
|
|
|
|
| |
No sound comes from | • Squelch level is too deep. |
| • Set squelch to the threshold point. | p. 8 | |
the speaker. | • Volume level is too low. |
| • Set [VOL] to a suitable level. | p. 8 | |
| • Speaker has been exposed to water. |
| • Drain water from the speaker. | — | |
|
|
|
|
| |
Transmitting is impossi- | • Some channels are for low power or re- |
| • Change channels. | pgs. | |
ble, or high power can - | ceive only. |
|
|
| 6, 26 |
not be selected. | • The output power is set to low. |
| • Push [HI/LO] to select high power. | p. 8 | |
|
|
|
|
| |
Scan does not start. | • “TAG” channel is not programmed. |
| • Set the desired channels as “TAG” chan- | p. 13 | |
|
|
| nels. |
| |
|
|
|
|
| |
No beep sounds. | • Beep tone is turned OFF. |
| • Turn the beep tone ON in SET mode. | p. 15 | |
|
|
|
|
| |
Receive signal cannot | • Optional voice scrambler is turned OFF. |
| • Turn the optional voice scrambler ON. | p. 10 | |
be understood. | • Scramble code is not set correctly. |
| • Reset the scramble code. | p. 16 | |
|
|
|
|
|
|
25
