Icom IC-M503 Dualwatch/Tri- watch operation, Starting a scan, Setting tag channels

12HM-134 REMOTE-CONTROL MICROPHONE

■Starting a scan

qWhile pushing and holding [H/L], push [DIAL] several times to select the channel group (USA or INT), if desired.

wPush [SCAN] to start priority or nor- mal scan.

•“SCAN” appears during normal scan.

•The priority channel readout indicates “16”, and “P” and “SCAN” indicators ap- pear during priority scan.

•When a signal is received, scan pauses until the signal disappears or resumes after pausing 5 sec. according to set mode setting (Channel 16 is still moni- tored during priority scan).

•Push [Y]/[Z] to check the scanning tag channels, to change the scanning direc- tion or resume the scan manually.

eTo stop the scan, push [SCAN].

•“SCAN” disappears.

•Pushing [PTT], [16•C] or [DIAL] also stops the scan.

■Setting tag channels

qWhile pushing and holding [H/L],

push [DIAL] several times to select the channel group (USA and INT), if desired.

wPush [Y]/[Z] to select the desired

channel to set as a tag channel.

ePush and hold [SCAN•TAG] for 1 sec. to set the displayed channel as a tag channel.

• “ ” appears.

rTo cancel the tag channel setting, push and hold [SCAN•TAG] for 1 sec.

• “ ” disappears.

•Clearing all tag channels in the selected channel group

➥While pushing and holding [H/L], push [SCAN•TAG] for 3 sec. to clear- ing all tag channels. (until long beep changes to 2 short beeps)

■Dualwatch/Tri- watch operation

qPush [Y]/[Z] to select the desired channel.

•While pushing and holding [H/L], push [DIAL] several times to select the chan- nel group (USA, INT), if desired.

wPush [DUAL] to start dualwatch or tri-watch.

•“DUAL” appears during dualwatch; “TRI” appears during tri-watch.

•Beep tone sounds when a signal is re- ceived on Channel 16.

•Tri-watch becomes dualwatch when re- ceiving a signal on the call channel.

eTo cancel dualwatch/tri-watch, push [DIAL] again.

36