STEP 8 (See Diagram 8)

A.) Attach the Seat (#40) to the Leg Developer Frame (#15). Secure it with two 5/8” Washers (#107) and M8 x 2 ½” Allen Bolts (#101).

B.) Attach both Left Handlebar (#32) and Right Handlebar (#33) to the Leg Developer Frame (#15) underneath the Seat (#40). Secure them with two M10 x 2 ¾” Carriage Bolts (#90), ¾” Washers (#106), and M10 Aircraft Nuts (#110).

C.) Attach two 1” x ½” Bushings (#55) to the Leg Developer (#23). Attach the Leg Developer to the bracket on the Leg Developer Frame (#15). Secure it with one M12 x 3 1/8” Hex Head Bolt (#91), two 1” Washers (#105), and one M12 Aircraft Nut (#105).

D.) Insert two Foam Roll Tubes (#37) halfway through the holes on the Leg Developer (#23) and Leg Developer Frame (#15). Push four Foam Rolls (#66) onto the tubes from both sides. Close the ends with four 2” Round End Caps (#74). Insert a L-Shaped Pin (#112) into the hole on the bracket on the Leg Developer Frame (#15) to lock the Leg Developer (#23) in place. Remove the Pin when using.

E.) Attach the Arm Curl Pad (#42) to the Arm Curl Stand (#22). Secure it with two 5/8” Washers (#107) and M8 x 5/8” Allen Bolts (#102).

F.) Insert the Arm Curl Stand (#22) into the opening on the Leg Developer Frame (#15). Secure it with a Quick Release Pin (#62).

DIAGRAM 8

12

Page 13
Image 13
Impex MWB CR 4 manual Diagram