STEP 11 (See Diagram 11 & 15)
A.) | Attach one end of the 327 ½” Leg Press Cable (#83) to the bracket on the Leg Press Pivot Arm |
| (#18). (See C View) Secure it with one M10 x 1” Allen Bolt (#99), two ∅ ¾” Washers (#106), and |
| one M10 Aircraft Nut (#110). NOTE: Do not over tighten this bolt. Make sure the head of the |
| cable can swivel on the bolt. |
B.) | Draw the Cable to the Vertical Supports (#16). Install a Pulley (#58). Secure it with one M10 x 5” |
| Allen Bolt (#96), two ∅ ¾” Washers (#106), and one M10 Aircraft Nut (#110). Draw the Cable |
| over this Pulley back to the Leg Press Pivot Arm (#18). Install another Pulley using one M10 x 1 ¾” |
| Hex Head Bolt (#92), two ∅ ¾” Washers (#106), and one M10 Aircraft Nut (#110). |
C.) | Draw the Cable towards back of the machine to the bottom of the Right Vertical Beam (#3). |
| Install a Pulley (#58) using one M10 x 1 ¾” Hex Head Bolt (#92), two ∅ ¾” Washers (#106), and |
| one M10 Aircraft Nut (#110). (See D View) |
D.) | Draw the Cable over the Pulley back to the Bench Press Frame (#11). Install a Pulley with one |
| M10 x 8 ½” Axle (#95), two ∅ ¾” Washers (#106), and two M10 Aircraft Nuts (#110). |
E.) | Draw the Cable back to the Right Vertical Beam (#3). Install a Pulley. (See D View). |
F.) | Draw the Cable to the Bench Press Frame (#11) and install another Pulley. |
G.) | Draw the Cable back to the Right Vertical Beam (#3) through the hole to the back of the Beam. |
| Install another Pulley. |
H.) | Draw the Cable upward to the Single Floating Pulley Bracket (#27) previously installed in STEP |
| 9E. Install another Pulley. |
I.) | Draw the Cable over the Pulley downward to the bracket on the Right Base Frame (#1). Install |
| another Pulley. |
J.) | Draw the Cable all the way up to the bottom of the Right Upper Frame (#6). Install another Pulley. |
K.) | Then draw the Cable downward to install a Pulley to a Double Floating Pulley Bracket (#30). Let |
| the Bracket hanging for now. |
L.) | Finally draw the Cable upward to the Single Floating Pulley Bracket (#27) previously installed in |
| STEP 10C. Secure the end of the Cable to the Bracket with one M10 x 1” Allen Bolt (#99), two ∅ |
| ¾” Washers (#106), and one M10 Aircraft Nut (#110). |
15
