Page 18
Operating the Mondopad Software
For informaon about the Mondopad Soware, refer to the Mondopad Soware Guide on the web at www.infocus.com/
Mondodocs.
INF7020 Menu System
To operate the menu, press the MENU buon. Use the arrow buons to select a menu opon, enter submenus and make adjust-
ments. Press the MENU buon twice to close the menu.

NOTES:

• Menus dier depending on the input mode.
• Aer 15 seconds of inacvity, the menu screen will close automacally. The excepons are the Date/Time Seng and Schedule
menus, which close aer approximately 4 minutes of inacvity.
• Items that cannot be selected are grayed-out.
• You can move the menu screen posion by pressing the Display buon.

Screen Menu

19 2 0 x 1 080V: 60 Hz H: 67.5 kHz
AUTO
CLOCK
PHASE
H-POS
V-POS
H-SIZE
V-SIZE
H-RESOLUTION
V-RESOLUTION
RESET
SCREEN
PICTURE
AUDIO
SETUP
OPTION
PIP/PbyP
600
25
610
37
50
50
1920
1080
SCREEN 1/1
END···[MENU]
PC D-SUB
AUTO: Automacally adjusts the clock, phase, horizontal and vercal posioning of the PC source signals. Press the right arrow but-
ton to acvate this funcon.
CLOCK: Adjusts the frequency of the sampling clock of PC source signals. Adjust the clock when ickering is noceable in the form of
vercal stripes. When adjusng the clock sengs, adjust unl no vercal stripes are noceable.
PHASE: Adjusts the sampling clock phase of PC source signals. Useful when small characters appear with low contrast and /or ick-
ering is noceable at the corners of the image. When adjusng the phase sengs, adjust the phase unl no horizontal stripes are
noceable. NOTE: Adjust Clock sengs before adjusng the Phase sengs.
H-POS: Adjusts the horizontal posion of the image.
V-POS: Adjusts the vercal posion of the image.
H-SIZE: Adjusts the horizontal size of the image.
V-SIZE: Adjusts the vercal size of the image.
H-RESOLUTION: Sets the horizontal resoluon when the resoluon of the PC source signals is not recognized properly.
V-RESOLUTION: Sets the vercal resoluon when the resoluon of the PC source signals is not recognized properly.
RESET: Resets the Screen menu items back to factory default sengs. Select ON and press the menu buon to reset.