Page 21
INF7020 Hardware Guide
Setup Menu
OSD H-POSITION
OSD V-POSITION
SCREEN MOTION
MOTION TIME 1
MOTION TIME 2
MONAURAL AUDIO
LANGUAGE
POWER ON DELAY
1/3
0 S
ENGLISH
OFF
OFF
PC D-SUB
SETUP
SCREEN
PICTURE
AUDIO
SETUP
OPTION
PIP/PbyP
OK···[MENU]MOVE OSD···[DISPLAY]
19 2 0 x 1 080V: 60 Hz H: 67.5 kHz
50
50
OSD H-POSITION: Adjusts the horizontal display posion of the menu screen.
OSD V-POSITION: Adjusts the vercal display posion of the menu screen.
SCREEN MOTION: Reduces residual images by moving the screen.
PATTERN1 - The whole screen moves vercally and horizontally.
PATTERN2 - A black screen spreads from the boom of the screen and then shrinks to the boom
of the screen.
PATTERN3 - A black bar moves from the le end to the right end of the screen.
PATTERN4 - Black screens appear from both the top and boom of the screen, and the displayed image.
MOTION TIME 1: Used to specify when Screen Moon starts.
MOTION TIME 2: Used to specify the length of me Screen Moon operates.
MONAURAL AUDIO: Outputs all audio signals as monaural audio.
LANGUAGE: Sets the display language for the menu screen.
POWER ON DELAY: Delays the image from displaying on the monitor for 1-60 seconds (1-second increments). When this funcon is
acve, the Power LED ashes orange. This funcon is disabled when 0 is seclected.
STANDBY MODE: When STANDARD is selected, the startup me from standby mode is reduced, however power consumpon dur-
ing Standby will increase. When LOW POWER is selected, power consumpon is reduced during standby mode, however the startup
me will increase. Certain RS232C commands will not be available either. STANDBY MODE cannot be set to LOW POWER when
SCHEDULE is ON or when the LED funcon in the FUNCTION menu is OFF.
OFF IF NO OPERATION: Determines whether or not the monitor goes into standby mode aer 4 hours of inacvity.
HOT PLUG CONTROL: Allows hot plug control of an HDMI source.
ID NO. SET: Not applicable.
AUTO ASSIGN ID NO.: Not applicable.
BAUD RATE: Selects the communicaon speed used for RS232C communicaon.
AUTO ASSIGN FIXED IP ADDR.: Set DHCP CLIENT to OFF for the monitor connected to the RS232C output terminal. A xed IP ad-
dress is automacally allocated. If the IP address is a duplicate with a network device other than the monitor, individually change the
IP address.
SPEAKER SELECT: Selects the speaker (internal or external) to be used.
HDMI AUTO VIEW: When ON is selected, the screen size is adjusted automacally according to the screen size control signal in-
cluded in the video signal input from the HDMI input.
COPY SETTING VALUE: Not applicable.
LOGO SCREEN: Displays and turns o the logo screen.