Page 36
RS232C Command Table
COMMAND: Command eld.
DIRECTION:
• "W" is used when the “Parameter” is set in the parameter eld. The command funcons are described under
“Control/Response Contents”.
• "R" is the returned value indicated under “Reply” which can be obtained by seng “????”, “˽ ˽ ˽ ?” or “???+”
(repeater control) in the parameter eld.
PARAMETER: Parameter eld.
REPLY: Response (Returned value)
Column 1:
“●” indicates a command which can be used in standby mode regardless of the STANDBY MODE seng.
“○” indicates a command which cannot be used in standby mode when STANDBY MODE is set to LOW POWER.
“–” indicates a command which cannot be used in standby mode regardless of the STANDBY MODE seng.