Integra DTR-5.5 Using the Tuner, Listening to the Radio, Tuning into Radio Stations

DTR-6.5,5.5_En.book Page 56 Wednesday, July 28, 2004 9:07 AM

Basic Operation—Continued

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

Listening to the Radio

1	Use the [TUNER] input selector
	button to select either AM or FM.
	In this example, FM has been selected.
	Band	Frequency

(Actual display depends on country.)

Tuning into Radio Stations

1 2

Zone 2

Standby

■ Auto Tuning Mode

1	Press the [Tuning Mode] button
	so that the AUTO indicator
	appears on the display.
2	Press the Tuning Up or Down [ ]/
	[ ] button.

Searching stops when a station is found.

■ Manual Tuning Mode

1	Press the [Tuning Mode] button
	so that the AUTO indicator disap-
	pears from the display.
2	Press and hold the Tuning Up or
	Down [ ]/[ ] button.
	The frequency stops changing when
	you release the button.
	Press the buttons repeatedly to change
	the frequency one step at a time.

The American model changes FM frequency in 0.2 MHz steps, 10 kHz steps for AM. For other models it’s 0.05 MHz steps for FM and 9 kHz steps for AM.

In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

TUNED AUTO

FM STEREO

56