Integra DTR-5.5 instruction manual TV Format Setup not American models, First Time Setup—Continued

DTR-6.5,5.5_En.book Page 45 Wednesday, July 28, 2004 9:07 AM

First Time Setup—Continued

TV Format Setup (not American models)

Here you can specify the TV format used in your area.

1

Receiver

Press the [Receiver] button fol- lowed by the [Setup] button.

The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “1. Initial Setup,” and then press [Enter]. The Initial Setup menu appears.

3

Enter

Use the Up and Down []/[ ] buttons to select “3. Hardware Setup,” and then press [Enter].

The Hardware Setup menu appears.

Enter

Menu
------------------------
Basic Setup
1.Initial Setup	-
1-----------------------.Initial Setup

1.Digital Input
1-3.Hardware Setup
------------------------2.Component Video
Advanced Setup
3a..HardwarePowered Zone2Setup
3.Surround Setup
:Not Activated
4.Audio Adjust
b.Zone2 Out
5.Listening Mode Preset
6.Preference	:Fixed
c.Sp Impedance Minimum
	:6ohms
d.TV Format	:AUTO

	(Menus vary depending on country.)
4	Use the Up and Down [ ]/[ ]
	buttons to select “c. TV Format,”

and then use the Left and Right

Enter

[]/[ ] buttons to select:

Auto: Conforms with the video input signal.

PAL: Select if the TV system in your area is PAL.

NTSC: Select if the TV system in your area is NTSC.

5	Press the [Setup] button.
	The setup menu closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

45