Integra DTR-5.5 2–4 1, Zone 2—Continued, Setting the Powered Zone, The setup menu closes

DTR-6.5,5.5_En.book Page 75 Wednesday, July 28, 2004 9:07 AM

Zone 2—Continued
Setting the Powered Zone 2					4	Use the Up and Down [ ]/[ ]
To use Zone 2, you must make this setting. It enables the						buttons to select “a. Powered
						Zone 2,” and use the Left and
speakers connected to the ZONE 2 SPEAKERS termi-
						Enter
nals so that they produce sound when Zone 2 is used.						Right [ ]/[ ] buttons to select:
	7	8	9
	Phono			TV VOL		Menu
	+10	0	Clear
						------------------------
	--/---
		Input Selector				Basic Setup
		Macro				1.Initial Setup	-
	1	2	3	Zone 2		1-----------------------.Initial Setup
						1.Digital Input
		Remote Mode
1						1-3.Hardware Setup
	Receiver	DVD	CD	MD/CDR		------------------------2.Component Video
						Advanced Setup
	Tape					3a..HardwarePowered Zone2Setup
						3.Surround Setup
	TV	VCR	Cable	SAT		:Not Activated
						4.Audio Adjust
						b.Zone2 Out
						5.Listening Mode Preset
	Dimmer			Sleep		6.Preference :Fixed

2, 3

TV		enu		M	en
		pM
Input	o				u
	T
+
CH			Enter			VOL
Disc
-		E			e
			xit
				id
Prev				Gu
	R	eturn			p
CH				Setu
Display						Muting
Rec						Random
Audio	Subtitle			Angle		Last Memory
Surround		All ST		THX		Stereo
Repeat		A-B		Search		Memory
Pure A		Direct		DSP		DSP
Test Tone	CH SEL			Level-		Level+
Open/Close	Video Off
				L Ni ht		Re EQ

2–4

1, 5

Not Activated: Zone 2 SPEAKERS terminals deactivated.

Activated: Zone 2 SPEAKERS termi- nals activated.

When Zone 2 is activated and turned on (see page 77), the speakers connected to the ZONE 2 SPEAKERS terminals output sound, but the speakers con- nected to the SURROUND BACK SPEAKERS terminals do not. (When Zone 2 is activated but not used, the surround back speakers work as nor- mal.)

1

Receiver

Press the [Receiver] button fol-	5	Press the [Setup] button.
lowed by the [Setup] button.
		The setup menu closes.

The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “1. Initial

Enter	Setup,” and then press [Enter].
	The Initial Setup menu appears.

Enter

3	Use the Up and Down [ ]/[ ]
	buttons to select “3. Hardware

Enter	Setup,” and then press [Enter].
	The Hardware Setup menu appears.
Enter

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

75