Integra DTR-5.5 Using the Remote Control in Zone, Using the 12V Trigger, Zone 2—Continued

DTR-6.5,5.5_En.book Page 78 Wednesday, July 28, 2004 9:07 AM

Zone 2—Continued

Using the 12V Trigger

When the AV receiver’s 12 V TRIGGER OUT A/B/C jack is connected to the 12 V TRIGGER IN jack on a connected component, the AV receiver can be configured so that the component is turned on automatically when Zone 2 is used. See page 73 for details.

Adjusting the Bass & Treble for Zone2

You can adjust the bass and treble for Zone2.

Using the Remote Control in Zone 2

To use the remote controller to control the AV receiver from Zone 2, you’ll need one of the following commer- cially available multiroom remote control kits:

•Multiroom Kits such as those made by Niles and Xan- tech.

These kits can also be used when the AV receiver is not in line of sight of the remote controller, for example, when it’s installed inside a cabinet.

1

Zone 2

Standby

Using a Multiroom Kit with Zone 2

In the following diagram, an IR receiver picks up the infrared signals from the remote controller in Zone 2 and feeds them to the AV receiver in the main room via the connecting block.

•On the Remote Setup menu, set the IR IN Position set- ting to “Zone 2” (see page 72).

2

1	Press the [Tone] button repeat-
	edly to select either Bass or
	Treble.

Connecting block

Main room

IR Receiver

Remote controller

Zone 2

2	Use the Controller [ ]/[ ] but-
	tons to adjust.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

Signal flow

Connect the miniplug cable from the connecting block to the AV receiver’s IR IN jack as shown below.

from the connecting block

Miniplug cable

78