Integra DTR-7.3 Connecting the remote zone Zone 2 speakers, When using the ZONE 2 OUT terminals

Connecting the remote zone (Zone 2) speakers

The DTR-7.3 allows you to watch and listen to two separate input sources at the same time. This allows you to, for example, place speakers and a television in two different rooms so that two or more people can enjoy two different movies at the same time. The room where the DTR-7.3 is actually located is referred to as the main room while the separate room is referred to as the remote zone (Zone 2). In addition, the IR IN/OUT terminal of the DTR-7.3 allows you to control the DTR-7.3 from the remote zone (Zone 2) with the remote controller even though the remote zone is physically separated. The diagram below shows how to make the proper connections for the remote zone.

When using the SURR BACK/ZONE 2 SPEAKERS terminals

If you are using a 5.1-channel speaker system in the main room, you can connect the speakers for the remote zone (Zone 2) to the open SURR BACK/ZONE 2 SPEAKERS terminals.

With this connection, select “Zone 2” for the Hardware Setup → Surr Back/Zone2 → Surr Back/Zone 2 setting in the Setup menu (see page 42).

Main Room			Remote Zone (Zone 2)
	PRE OUT		Zone 2	Zone 2
FRONT	R	L
			Left	Right
SUB		CENTER	speaker	speaker
SURR
SURR	R	L
BACK/
ZONE 2

Left (white)

Power amplifier

DTR-7.3 Right (red)

When using the ZONE 2 OUT terminals

Main Room

SURR

BACK/

ZONE 2

SPEAKERS

RL

DTR-7.3

Remote Zone (Zone 2)

Zone 2		Zone 2
Left		Right
speaker	speaker

When you have connected all the speakers for 7.1-channel audio in the main room, connect the speakers as shown below.

The ZONE 2 OUT terminal is a constant output. Connect to the LINE input of the amplifier (CD, tape, etc.). Adjust the volume with the amplifier connected to the ZONE 2 OUT terminal.

1.Connect the DTR-7.3 to the amplifier for the remote zone.

2.Connect the remote zone speaker cables to the speaker terminals on the amplifier.

3.Connect the DTR-7.3 to the monitor for the remote zone.

Remote Zone (Zone 2)

Zone 2	Zone 2 monitor	Zone 2
Left speaker	or projector	Right speaker

Note:

It is important to be aware of the speaker impedance (see page 41).

When using the SURR BACK/ZONE 2 PRE OUT terminals

If you are using a 5.1-channel speaker system in the main room, you can connect the amplifier for the remote zone (Zone 2) to the open SURR BACK/ZONE 2 PRE OUT terminals and connect the remote zone speakers.

With this connection, select “Zone 2” for the Hardware Setup → Surr Back/Zone 2 → Surr Back/Zone 2 setting in the Setup menu (see page 42).

Zone 2 amplifier
			Main Room
	AUDIO	VIDEO	S VIDEO
			MONITOR
			OUT
R	L
Right (red)	OUT		ZONE 2
Left (white)			DTR-7.3

Note:

The ZONE 2 out terminals of the DTR-7.3 are of a fixed output level.

24