Integra DTR-7.3 Before using this unit, Installing the remote controller batteries

Before using this unit

Installing the remote controller batteries

1.Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below.

2.Insert two AA (R6 or UM-3) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (–) symbols) inside the battery compartment.

3.After the batteries are installed and seated correctly, replace the compartment cover.

1 2 3

Using the remote controller

Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller.

Remote control sensor

DTR-7.3

STANDBY indicator

Notes:

• Do not mix new batteries with old batteries or different kinds of

batteries.

30˚

30˚

Notes:

Approx. 16 feet (5 meters)

• To avoid corrosion, remove the batteries if the remote controller

will not be used for a long time.

• Remove dead batteries immediately to avoid damage from

corrosion. If the remote controller does not operate smoothly,

remove the old batteries and replace them both with two new AA

batteries.

•Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller.

•Using another remote controller in the same room or using the DTR-7.3 near equipment that uses infrared rays may cause operational interference.

•Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.

•Make sure the audio rack doors do not have colored glass. Placing the DTR-7.3 behind such doors may prevent proper remote controller operation.

•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

7