Enjoying music or videos with the
Display Dimmer
Input source buttons
RCVR
CH Sel Test
Level /
Display Dimmer
Switching the display
While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the Display button on the
Remote controller |
When an input source other than FM or AM is selected:
Adjusting the brightness of the front display
You can adjust the brightness of the front display of the
Remote controller | |||
|
|
|
|
Input
Program format*
Input + Listening mode or Multi Ch
*If the input signal does not have a program format, then this will be skipped.
*When the input signal is digital audio
The program format is displayed. For example, the display “Dolby D: 3/2.1” shows that the format is Dolby Digital with 5.1 discrete channels consisting of three front channels (front left, front right, and center), two surround channels (surround left and surround right), and the low frequency effect (LFE) channel.
When the front channel number is 2, they are the front left and front right; when it is 1, it is monaural. When the surround channel number is 1, it is monaural; when it is 0, there is no surround channel. When no LFE number is given, there is no LFE channel. Also, if there is no program format for the input signal, nothing will be displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display “PCM fs: 44.1k” shows that the signal is PCM and that the sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source:
FM/AM frequency +
ch
Preset no.
FM/AM +
Listening mode
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between
1. Press the RCVR Mode button.
2. Press the CH Sel button and select the desired speaker.
3. Press the Level or button to adjust the volume level.
Notes:
•You cannot select a speaker if it is set to “No” or “None” in the Speaker Config
•To have your new speaker levels set here overwrite the settings at Setup Menu → Speaker Setup Menu → Level Calibration
32