Integra DTR-7.8 Advanced Setup, Speaker Setup, Speaker Settings, Buttons to select Subwoofer

Advanced Setup

Speaker Setup

This section explains items on the Speaker Config menu.

Some of the speaker settings are set automatically by the Automatic Speaker Setup function (see page 53).

	Input Selector
	Macro
1	2	3	Zone3
	Remote Mode
DVD	VCR	CD	Zone2
		CDR/MD
TV	Cable	Dock	Receiver	Receiver
	SAT		Tape/AMP

1	Press the [Receiver] Remote
	Mode button, followed by the
Receiver	[Setup] button.
	The main menu appears onscreen.
S
et
u
p

	Dimmer			Sleep
		nu	Me
		Me
		op	nu
		T
Enter	+
	CH	Enter		VOL
	Disc
	Album
	-	G
			it
Setup	Prev	uide	Ex
		S	rn
	CH	etup	Retu
	Display			Muting
	Rec	Playlist		Random
		Listening Mode

Speaker Settings

2

Enter

Enter

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [Enter].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

See “Speaker Settings” on page 44.

Speaker Configuration

These settings are set automatically by the Automatic Speaker Setup function (see page 53).

With the Speaker Configuration settings, you can specify which speakers are connected and a crossover frequency for each speaker.

3

Enter

Enter

Use the Up and Down []/[ ] buttons to select “2. Speaker Config,” and then press [Enter].

The Speaker Config screen appears.

2-2.Speaker Config

Subwoofer		Yes
Front	Full Band
Center		100Hz
Surround		100Hz
Surr Back		100Hz
Surr Back Ch		2ch
LPF of LFE		120Hz
Double Bass		On

The following crossover frequencies can be specified: Full Band, 40 Hz, 45 Hz, 50 Hz, 55 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 90 Hz, 100 Hz, 110 Hz, 120 Hz, 130 Hz, 150 Hz, or 200 Hz.

Specify Full Band for speakers that can output low-fre- quency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover fre- quency will then be output by the subwoofer instead of the speaker. Refer to your speakers’ manuals to deter- mine the optimum crossover frequencies.

If you’re using THX-certified speakers, specify 80 Hz (THX) for all speakers.

4		Use the Up and Down [ ]/[ ]
		buttons to select “Subwoofer,”
		and then use the Left and Right
	Enter	[ ]/[ ] buttons to select:
		Yes: Select if a subwoofer is con-
		nected.
		No: Select if no subwoofer is con-
		nected.
	Enter

96