Manuals / Intel / Computer Equipment / Switch

Intel 1000LX Conﬁguring the Module, C H A P T E R 3 Configure the module and connect the cables

Models: 1000LX 1000SX

1 30

Download 30 pages 17.35 Kb

Page 13

C H A P T E R 3 Configure the module and connect the cables

C H A P T E R 3 Configure the module and connect the cables

Conﬁguring the Module

To change the module mode using Intel Device View

The default setting for the Module Mode is Stack Mode. With the switch containing the 1000Base Module displayed in the Device View window:

Warning Changing mode causes Intel Device View to save the switch conﬁguration and reset the switch.

1Right-click the 1000Base-SX/1000Base-LX port on the module and select Port Setup.

2Click the Module tab.

To change the port settings using Intel Device View

3Select the correct mode.

4Click OK. The conﬁguration is saved and the switch reset.

The 1000Base Module default port settings are — Port Enabled, Spanning Tree Disabled and Auto-negotiation Enabled. To change these settings:

1Right-click the 1000Base-SX/1000Base-LX port on the module and select Port Setup.

2Click the Port Mode tab.

3Set the port settings.

4Click OK.

10

Image 13

Intel 1000LX, 1000SX manual Conﬁguring the Module, C H A P T E R 3 Configure the module and connect the cables

Contents

User Guide 1000SX Module and 1000LX Module for 500 Series SwitchesUser Guide 1000SX Module and 1000LX Module for 500 Series Switches715236-001 First edition Year 2000 capableOctober 715236-001CLASS LASER PRODUCT Quick StartCLASS LASER PRODUCTNaming in this Quick Start This Quick Start covers two products 5 Turn on the switch Conﬁgure and cable the Configure the module using Intel Device View and cable up using 1000SX and 1000LX Modules Introduction Status Module LEDsIndicates Page The configuration and cabling of the 1000Base Module are very Conﬁgure the module and connect the cablesNote When the module mode is changed, the conﬁguration is automatically saved and Intel Device View resets theC H A P T E R 3 Configure the module and connect the cables Conﬁguring the ModuleStand-alone Mode Cabling the ModuleCabling to a Matrix Module in a group of switches Stack ModeNote Redundancy is not possible with the 510T 3 Plug the other end of the Stacking Cable into an empty port on the Matrix Module located on the same side of the switch for example, both modules in Slot A, and secure it using the latches on the connector Introduction Prevent network loops Link Aggregation with Two Modulesules in Slot A Server Page Speciﬁcations 62.5 μm 62.5 μm MMF up to 550 m 1804 ft†Limited Hardware Warranty Limited Hardware WarrantyReturning a Defective Product RMA A P P E N D I X A Limited Hardware Warranty Limited Hardware Warranty Europe onlyLIMITATION OF LIABILITY AND REMEDIES Returning a Defective Product RMAA P P E N D A Limited Hardware WarrantyCountry NumberWARNING Fiber-optic ports on 1000LX-Optical Safety WARNING Fiber-optic ports on 1000SX-Optical SafetyFederal Communications Commission FCC Statement Manufacturer DeclarationWARNUNG AVERTISSEMENTA P P E N D I X A Limited Hardware Warranty ADVERTENCIAS AVVERTENZAA P P E N D I X A Limited Hardware Warranty Customer Support Technicians Automated SupportNorth America only Country