Manuals / Intel / Computer Equipment / Switch

Intel 1000SX, 1000LX manual Cabling the Module, Stand-alone Mode

Models: 1000LX 1000SX

1 30

Download 30 pages 17.35 Kb

Page 14

Cabling the Module

CH A P T E R 3 Configure the module and connect the cables

	Cabling the Module
Introduction	The cable connections to the module depend on the mode in which
	the module is to be used.
	Stand-alone Mode
Cabling for a single switch	Follow these instructions to provide a high-speed (1000Base-SX/
	1000Base-LX) link between the switch containing the 1000Base
	Module and another switch, device or group of switches:
	Warning When used in stand-alone mode, this module must not
	be installed in a switch containing a Stack Interface
	Module, a Matrix Module or a 1000Base Module set in
	stack mode.
	1 Plug the SC connectors on the optic ﬁber cable into the RX and
	TX sockets on the 1000Base-SX/1000Base-LX connector.
	1000SX Module for 500 Series Switches
	CLASS 1 LASER PRODUCT
	1000Base-SX	Stack Interface Module
		1716

2Plug the other end of the cable into a device and check the LEDs on the 1000Base Module to verify the link. For informa- tion on the LEDs, see Chapter 2.

11

Image 14

Intel 1000SX, 1000LX manual Cabling the Module, Stand-alone Mode

Contents

1000SX Module and 1000LX Module for 500 Series Switches User Guide715236-001 1000SX Module and 1000LX Module for 500 Series SwitchesUser Guide October Year 2000 capableFirst edition 715236-001CLASS Quick StartCLASS LASER PRODUCT LASER PRODUCTNaming in this Quick Start This Quick Start covers two products 5 Turn on the switch Conﬁgure and cable the Configure the module using Intel Device View and cable up using 1000SX and 1000LX Modules Introduction Indicates Module LEDsStatus Page Note When the module mode is changed, the conﬁguration is Conﬁgure the module and connect the cablesThe configuration and cabling of the 1000Base Module are very automatically saved and Intel Device View resets theConﬁguring the Module C H A P T E R 3 Configure the module and connect the cablesCabling the Module Stand-alone ModeStack Mode Cabling to a Matrix Module in a group of switchesNote Redundancy is not possible with the 510T 3 Plug the other end of the Stacking Cable into an empty port on the Matrix Module located on the same side of the switch for example, both modules in Slot A, and secure it using the latches on the connector Link Aggregation with Two Modules Introduction Prevent network loopsules in Slot A Server Page Speciﬁcations 62.5 μm MMF up to 550 m 1804 ft† 62.5 μmReturning a Defective Product RMA Limited Hardware WarrantyLimited Hardware Warranty LIMITATION OF LIABILITY AND REMEDIES Limited Hardware Warranty Europe onlyA P P E N D I X A Limited Hardware Warranty Returning a Defective Product RMACountry A Limited Hardware WarrantyA P P E N D NumberFederal Communications Commission FCC Statement WARNING Fiber-optic ports on 1000SX-Optical SafetyWARNING Fiber-optic ports on 1000LX-Optical Safety Manufacturer DeclarationA P P E N D I X A Limited Hardware Warranty AVERTISSEMENTWARNUNG A P P E N D I X A Limited Hardware Warranty AVVERTENZAADVERTENCIAS North America only Automated SupportCustomer Support Technicians Country