Intel GA-G1975X Configuring SATA controller mode and boot sequence in BIOS Setup, English

English

(2)Configuring SATA controller mode and boot sequence in BIOS Setup

You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and set BIOS boot sequence for the SATA hard drive(s).

Step 1:

Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). If you want to create RAID, set SATA RAID/AHCI Mode under the Integrated Peripherals menu to RAID (Disabled by default). Then, set On-Chip SATA Mode to Manual or Auto (default) based on your own requirements.

CMOS Setup Utility-Copyright (C) 1984-2005 Award Software

Integrated Peripherals

On-Chip Primary PCI IDE	[Enabled]
SATA RAID/AHCI Mode	[RAID]
On-Chip SATA Mode	[Auto]
x PATA IDE Set to	Ch.0 Master/Slave
SATA Port 0/2 Set to	Ch.2 Master/Slave
SATA Port 1/3 Set to	Ch.3 Master/Slave
USB Controller	[Enabled]
USB 2.0 Controller	[Enabled]
USB Keyboard Support	[Disabled]
USB Mouse Support	[Disabled]
Legacy USB storage detect	[Enabled]
Onboard H/W Sound	[Enabled]
Onboard H/W 1394	[Enabled]
Onboard H/W GigaATA	[Enabled]
Onboard H/W LAN	[Enabled]
OnBoard LAN Boot ROM	[Disabled]
Onboard Serial Port 1	[3F8/IRQ4]
i-Lock	[Enabled]

Item Help

Menu Level

If a hard disk controller card is used, set at Disabled.

[Enabled]

Enable on-chip IDE Port.

[Disabled]

Disable on-chip IDE Port.

: Move	Enter: Select		+/-/PU/PD: Value		F10: Save	ESC: Exit	F1: General Help
F3: Language		F5: Previous Values		F6: Fail-Safe Defaults		F7: Optimized Defaults

Figure 1

The BIOS Setup menus described in this section may not show the exact settings for your motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you have and the BIOS version.

GA-G1975X Motherboard - 80 -