Intel manual Component Location and Description, Intel IXD1110 Demo Board Top View, IXF1110

IXD1110 Demo Board

1.3.2Component Location and Description

Figure 1 illustrates the top view of the IXD1110 demo board.

Figure 1. Intel® IXD1110 Demo Board (Top View)

GBIC SFP	GND	1.8 V IXF	2.5 V IXF	3.3 V	2.5 V
Connectors
Port 0
Port 1
Port 2				EPROM
Port 3		Mictor Connector			SMB Connectors
		Probe D
Port 4				FPGA
	JP1	®			SPI4-2
	J	Intel
	T	IXF1110			Connector
	A
	G
Port 5			Mictor Connector
				Probe C
Port 6			Mictor Connector
				Probe A
Port 7	Reset	JP2
Port 8	S1
Port 9			Intel® IXF1110
				LEDs

Table 1 provides a list of the various principal components found on the IXD1110 demo board.

Table 1. Intel® IXD1110 Demo Board Principal Components

Component	Description
IXF1110	10-port Gigabit MAC that supports IEEE 802.3 1000 Mbps applications. Refer to the
	IXF1110 Datasheet for additional information.
	The IXF1110 uses a serial interface consisting of three signals to provide LED data to
IXF1110 LEDs	an external driver. This interface provides the data for 30 separate direct drive LEDs
	and allows three LEDs per MAC port. Refer to Section 7.0, “LEDs” on page 19.
JP1	This jumper provides access to the JTAG test signals. Refer to Section 6.2, “JTAG
	Test Signals” on page 18.
JP2	This reset jumper is required for proper board operation. Refer to Section 6.1, “Reset
	Jumper JP2” on page 18 for more information.

1. For evaluation of the signals provided by the Mictor connector, use the corresponding logic analyzer probe.

Development Kit Manual 9

Document Number: 250807

Revision Number: 003

Revision Date: June 27, 2003