Intermec PD41 manual Extended Testmode Activating, Extended Testmode Selecting Function

Chapter 5 — Setting up the Printer

Extended Testmode: Activating

	Data/
Step Ready		Error	RtW	Button	Comment
1				1	Make sure the printhead is
					lifted. Press and hold the
					Print button and switch the
					printer On. Extended
					Testmode is activated after
					10 seconds.
2	flash	flash	flash		All 3 LEDs flash rapidly four
					times. Extended Testmode is

activated. Release button to continue.

Extended Testmode: Selecting Function

	Data/
Step Ready		Error	RtW	Button	Comment
					LEDs flash fast four times,
3	flash	flash	flash	0
					in four-second intervals.
4			flash		Lower the printhead.
5				1	Press the Print button and
					hold.

6Release the button when LED combination corresponding to your choice of function flashes. Then see corresponding function table below.

7a	0	0	1	Test Label function.
				Testfeed Mode Slow
7b	0	1	0
				function.
7c	0	1	1	Dump mode function.
				Factory default function.
7d	1	0	0
7e	1	1	1	Exit Extended Testmode.

The functions 7a-7e are described on the next page.

44 EasyCoder PD41 Printer User’s Guide