SECTION 6—BACK/SEAT

Installing/Replacing Seat Positioning Straps

NOTE: For this procedure, refer to FIGURE 6.5.

Installing

1.Remove the hex screw and locknut that secures the back cane to the back plate.

2.Position the seat positioning strap against the back plate.

3.Install the hex screw through the seat positioning strap, coved spacers and back cane.

4.Securely tighten the seat positioning strap to the wheelchair with the locknut.

5.Repeat STEPS 1-4 for opposite side.

Replacing

1.Remove the hex screw, locknut and seat positioning strap from the back plate of the wheelchair frame.

2.Discard existing seat positioning strap.

3.Install the new seat positioning strap to the wheelchair. Refer to Installing/Replacing Seat Positioning Straps on page 51.

Back Plate

Back Cane

 

Locknut

Seat Positioning Strap

 

Hex Screw

Coved Spacers

 

FIGURE 6.5 Installing/Replacing Seat Positioning Straps

Part No 1122134

51

Compass™SPT™

Page 51
Image 51
Invacare PHW93, PH904A manual Installing/Replacing Seat Positioning Straps