
SECTION
Adjusting T-Arm Sockets
NOTE: For this procedure, refer to FIGURE 5.7.
NOTE: Perform this procedure if the
1.Remove the rear wheels from the wheelchair, if necessary. Refer to Installing/Removing Rear Wheels on page 58.
2.Loosen, but DO NOT remove the four hex screws and washers that secure
NOTE: The
3.Slide the
4.Squeeze the
5.While holding the
6.Press IN on the locking lever and lift the
7.Repeat STEPS
8.If necessary, install rear wheels. Refer to Installing/Removing Rear Wheels on page 58.
Hex Screws
and WashersHex Screws and
Washers
Slot
Locking Lever |
FIGURE 5.7 Adjusting T-Arm Sockets
Part No 1122134 | 45 | Compass™SPT™ |