SECTION 2—SAFETY/HANDLING

Reaching and Leaning - Backwards

WARNING

DO NOT lean over the top of the back upholstery. This will change your center of gravity and may cause you to tip over.

NOTE: For this procedure, refer to FIGURE 2.3.

Position wheelchair as close as possible to the desired object. Point casters forward to create the longest possible wheelbase. Reach back only as far as your arm will extend without changing your sitting position.

FIGURE 2.3 Reaching and Leaning - Backwards

Tipping - Rear Wheel Configuration Only

WARNING

DO NOT tip the wheelchair without assistance.

When tipping the wheelchair, an assistant should grasp the back of the wheelchair on a non-removable (non-detachable) part. Inform the wheelchair occupant before tipping the wheelchair and remind him/her to lean back. Be sure the occupant’s feet and hands are clear of all wheels and/or pinch points.

After mastering the techniques of tipping the wheelchair, use one of the following methods to tackle curbs, short stairs, etc.

Tipping - Curbs: Method 1 - Wheelchair with Step Tubes

NOTE: For this procedure, refer to FIGURE 2.4 on page 21.

Place foot on the step tube and begin to tilt the wheelchair toward you. Apply a continuous downward motion until the balance point is achieved and the casters clear the curb. At this point, the assistant will feel a difference in the weight distribution.

Compass™SPT™

20

Part No 1122134

Page 20
Image 20
Invacare PH904A, PHW93 manual Reaching and Leaning Backwards, Tipping Rear Wheel Configuration Only