SECTION 5—ARMS
2.Replace the existing clothing guard with the new clothing guard and securely tighten with the existing hardware.
3.Repeat STEPS 1-2 for the opposite side if necessary.
Installing/Removing T-Arms
NOTE: For this procedure, refer to FIGURE 5.3.
Installing T-Arms
1. Position the T-Arm over the T-Arm socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards the front of the wheelchair.
2.Slide T-Arm into T-Arm socket until the locking lever is in the slot in the T-Arm socket and an audible “click” is heard.
3.Pull up on T-Arm to make sure T-Arm is locked in place.
NOTE: If the T-Arm does not slide in the T-Arm socket as desired, adjust the T-Arm socket. Refer to Adjusting T-Arm Sockets on page 45.
4.Adjust the T-Arm for desired height, width and depth, if necessary. Refer to Adjusting The T-Arms on page 43.
5.Repeat STEPS 1-4 for opposite side of wheelchair.
Removing T-Arms
1.Press the locking lever in and lift the T-Arm straight up and out of the T-Arm socket.
NOTE: If the T-Arm does not slide up and down in the T-Arm socket as desired, adjust the T-Arm socket. Refer to Adjusting T-Arm Sockets on page 45.
2. Repeat STEP 1 for opposite side of the |
Locking Lever (towards the front of
T-Armthe wheelchair) Socket
Slot
