SECTION 4—FRONT RIGGINGS

Composite/Articulating Footplate Heel Loop Replacement

NOTE: For this procedure, refer to FIGURE 4.12.

Disassembly

Composite

1.Remove the hex screw and coved spacer that secure the lower footrest assembly to the swing away footrest assembly.

2.Remove the lower footrest assembly.

3.Remove the mounting screw and locknut that secure the heel loop to the footrest.

4.Slide heel loop off of the footrest.

Articulating

1.Remove the mounting screws, washers and spacers that secure the heel loop to the articulating footplate.

Reassembly

1.Replace heel loop.

2.Reverse the disassembly procedures.

NOTE: When securing the heel loop to the footrest assembly, tighten mounting screw until the spacer is secure.

Composite Footplate

 

 

Swingaway Footrest Assembly

Mounting

Hex Screw and

Mounting

Coved Spacer

Screw

Lower Footrest

Screws

 

 

 

Assembly

Washer

 

 

Spacer

 

Heel

 

 

Heel

 

Loop

 

 

Loop

Spacer

 

Locknut

Articulating

Footplate

FIGURE 4.12 Composite/Articulating

Footplate Heel Loop Replacement

Replacing Sector Block

NOTE: For this procedure, refer to FIGURE 4.13.

1.Remove the hex screw and washer that secure the existing sector block to the front rigging support tube.

2.Position the new sector block on the front rigging support tube. Make sure the locking pin is facing up.

3.Secure the new sector block to the front rigging support tube with the existing hex screw and washer.

Wheelchair

Hex Screw

 

Frame

Washer

 

Locking Pin

Sector Block

 

FIGURE 4.13 Replacing Sector Block

Compass™SPT™

38

Part No 1122134

Page 38
Image 38
Invacare PH904A, PHW93 manual Replacing Sector Block, Composite/Articulating Footplate Heel Loop Replacement