Invacare Pronto M51 Base Charging Using An Independent Charger Plugged Into The Joystick

SECTION 9—BATTERIES
Part No. 1148076 61 Pronto® M51™ Base with SureStep®
Charging Using An Independent Charger Plugged Into The Joystick
 WARNING
Read and carefully follow the individual instructions for each charger (supplied or
purchased). If charging instructions are not supplied, consult a qualified technician
for proper procedures.
DO NOT attempt to recharge the batteries using both the on-board battery
charger and an independent battery charger (plugged into the joystick charger
port) at the same time. Doing so will reduce the life of the batteries.
CAUTION
Only use a charger approved by Invacare when charging through the joystick on this
wheelchair model.
DO NOT use an independent charger with an output rating of over 8A (Amps).
Otherwise, damage may occur.
NOTE:Forthisprocedure,refertoFIGURE 9.7.
NOTE:Thechargerportlocatedonthefrontofthejoystickrequirestheuseofanindependent��
charger.TheindependentchargerisNOTsuppliedwiththewheelchair.
1. Attachthebatterychargerconnectortothechargerportonthefrontofthejoystick.
2. Plugthecharger’sACpowercordorextensionintothegrounded110‐voltwalloutlet.
3. Whenchargingiscomplete,turnchargerOff.
4. Disconnectoutputcablefromjoystickchargerport.
FIGURE 9.7 Charging Using An Independent Charger Plugged Into The Joystick
MPJ+ Joystick
SPJ+ Joysticks
Charger/
Programming
Port
Charger/Programming Port (On
Front of Joystick)