SECTION 9—BATTERIES
Using the Proper Batteries
NOTE: For this procedure, refer to FIGURE 9.1.
1.Place battery on ground/flat surface.
2.Visually draw a horizontal and vertical centerline through the middle of battery (FIGURE 9.1).
3.Position the battery so that the terminals are above the horizontal centerline.
4.Visually inspect the battery to ensure the correct position of the POSITIVE and NEGATIVE terminals (FIGURE 9.1).
WARNING
Batteries with terminal configuration as shown below MUST be used. Batteries that have the reverse terminal configuration MUST NOT be used - otherwise injury and damage may occur.
Use This Configuration | DO NOT Use | |
NEGATIVE |
|
|
| POSITIVE (+) | |
Battery Terminal |
| Battery Terminal |
|
|
|
NEGATIVE (-)
Battery Terminal
U1 Battery | POSITIVE (+) | U1 Battery |
| Battery Terminal | |
|
|
FIGURE 9.1 Using the Proper Batteries
Pronto® M51™ Base with SureStep® | 52 | Part No. 1148076 |
