IOGear GWHDMS52 user manual Remote Control, Info Button, IR Button, Battery Compartment

Remote Control

	1
	2
7	3
	4
	5
	6

8

1.POWER ON / POWER OFF Buttons Press Power ON to turn the Transmitter

&Receiver ON. Press Power OFF to turn the Transmitter & Receiver OFF. When both Transmitter & Receiver Power LEDs are red, press Power ON to the Receiver to wake-up both the Receiver and Transmitter automatically.

2.INFO Button

Press this button to the Transmitter or Receiver to display OSD for system related information on HDTV.

3.TRANSMITTER NO. Button Press to switch different transmitter inputs. Please refer to page 24, Multiple Transmitter Selection section

4.SOURCE Button

Press to select the audio/video source inputs to the Transmitter or Receiver. Press OK to switch to the source input selected.

5.Up and Down Arrow Buttons Press to select the audio/video source inputs for transmitter display. Press OK to switch to the source input selected.

6.Left and Right Arrow Buttons Press to select the audio/video source inputs for receiver display. Press OK to switch to the source input selected.

7.IR Button

Press to switch the IR Blaster frequency to meet Source device’s requirement. It can switch the IR Blaster frequency from 47KHz to 56KHz to 38KHz recurring.

8.Battery Compartment

•Remove the remote control battery door by pushing the bottom clip in and lifting on the battery door

•Place the two AAA batteries into the remote control and replace the battery door until it snaps in place

11