
7.If operation is normal, the POWER/Wireless status LED and Source Status LED will glow in solid green. Please refer to the LED status table below that contains detailed LED indicator and OSD descriptions for the transmitter and receiver:
| Status | Tx / Rx | Tx/Rx | Rx | Rx |
| |
Item / Mode | Power | Source | Video | Wireless | OSD Display | ||
Description | |||||||
| LED | LED | LED | LED |
| ||
|
|
| |||||
Standby | For power saving | Static | off | off | off |
| |
| mode. | Red |
| ||||
|
|
|
|
| |||
Initial Boot |
| Tx |
|
|
| 4 levels | |
up / Warm | It will spend 15 ~ | Blinking |
|
|
| ||
up | 20 seconds for | Green | Blinking | Blinking | Blinking | looping | |
| |||||||
| system boot up. | Rx Static |
|
|
|
| |
|
| Green |
|
|
|
| |
Searching | Continuing search | Tx |
|
|
| x | |
available | available channels |
|
|
| |||
Blinking |
|
|
|
| |||
channels | If system can’t |
|
|
|
| ||
Green | Blinking |
| Blinking |
| |||
| establish link |
|
| ||||
| Rx Static |
|
|
|
| ||
| over 80s after |
|
|
| Looping display | ||
| Green |
|
|
| |||
| initialization. |
|
|
| these two OSD | ||
|
|
|
|
| |||
Wireless | No input from | Static | Blinking | Blinking | Static |
| |
linked Mode |
| ||||||
selected source |
| ||||||
| Green | (Quickly) | (Quickly) | Green |
| ||
| (Note B) | x | |||||
|
|
|
|
| |||
| Video format not | Static | Blinking | Blinking | Static |
| |
| recognized |
| |||||
| Green | (Slowly) | (Slowly) | Green |
| ||
| (Note C) |
| |||||
|
|
|
|
|
| ||
| Video format is | Static | Static | Static | Static | - | |
| recognized | Green | Green | Green | Green | ||
|
|
Notes:
A.If the RF connection
B.Please make sure the source device has been powered ON and the signal output is set to HDMI out; also try to
C.If there is no video displayed and OSD display shows “Not Supported Format”, this is an indication that the video resolution or frame rate from the computer is not supported, please refer to page 26 to switch to a supported video resolution.
D.If you have more than one pair of this product, each transmitter and receiver should be at least 6.5 feet away from one another.
19