Step 3: Setup the IR blaster extender cable and IR sensor extender cable
The IR relays infrared commands from your remote control to your device.
Users can control their AV devices by pointing their remote control to the receiver or IR sensor extender cable. (IR distance from remote to receiver / IR sensor cable is 30 feet line of sight.)
A: Transmitter
1.Plug the IR Blaster cable in to the IR “Out” jack of the transmitter.
2.Apply the IR blaster head directly over the eye of the IR sensor of your High Definition audio/ video device. This allows the remote control of your devices from another room when using the wireless receiver.
IR Blaster Extender cable |
|
Note: Transmitter and source devices connected to the Transmitter within the local location must all be in line of site for IR control.
B: Receiver
1.Place the wireless receiver out of sight and use the IR Sensor extender for remote control of your devices.
2.Plug the IR Sensor Extender cable into the IR “IN” jack of the receiver and place sensor on front of the TV for convenient operation.
Note: In some instances, the IR sensor on your source device may be difficult to find. To help simplify this process, cut a piece of cardboard to the same size as the front panel of your source device and place a 1 inch hole in the middle of the cardboard. Power ON your source device and play a movie or other video content. Place the cardboard hole over the left side of the source device and using the source device’s remote control directly over the cardboard hole, press the pause button repetitively while gradually moving the cardboard hole from left to right making sure to keep the remote control’s beam directly over the cardboard hole. Once the source device recognizes the pause button being pressed, you have located the position of the remote control IR sensor on the source device and that is where you will place the IR Blaster’s sensor. The IR sensor supports 38KHz, 47KHz and 56KHz (NEC, RC5, RC6) remote signal protocol.
14
