Step 3: Install the Wireless PIR Detectors
Installing the Wireless PIR Detectors
1.
2.
3.
4.
5.
6.
7.
On then rear of each detector is a sticker indicating the pre- programmed zone number. Starting with Zone 1, power up the detector by removing the plastic insulator under one the batteries. Then wait 3 minutes for the detector to warm up.
Remove plastic from under battery terminal
Set dipswitches 1 and 3 on the main control unit to on.
Open and close the front cover of the detector. The detector can now be walk tested for 3 minutes.
Walk test the detector and adjust facing angle as necessary so that the red light on the detector turns on whenever you walk past it. The unit will beep out the zone number of the detector whenever it is triggered i.e. zone 1 will beep once. The unit will not beep out the zone number if the radio signal strength is not strong enough.
For information on Walk Test see page 22 and page 43.
Mount the detector if walk test was successful.
Press Button 2 to exit Walk Test mode. | ||
ZONE | By default zones are active in both home and away modes. | |
FEATURE | ||
To modify the zone’s features continue following this | ||
PROGRAM | procedure, otherwise go to step 10. | |
17
