Figure 9
Figure 10
Installing the Siren Unit
1.Drill mounting holes (7mm diameter, 25mm minimum in depth) into the chosen wall.
2.If a masonry wall, use the green star plugs. Press each one into the 4 main mounting holes.
3.Make a 12mm hole and feed the 10m of low voltage power cable through the wall and up into the ceiling for power.
4.Screw the top 2 screws half way in.
5.Place the unit to support itself from the top 2 screws through the key shape holes at the top of the main control unit
6.Screw in and tighten the bottom two mounting screws then tighten the top two screws.
7.Now run the 10m of low voltage cable through the roof to the closest power point.
8.Plug the power adapter into your power point, connect the 10m cable, and then turn the power point on.
9.Now turn the key switch on the outdoor siren to the ON position (clockwise).
10.Perform Wireless Siren Auto Test.
Plug on power adapter | Socket on 10m of |
connected to power point | cable from the siren |
Note: If for any reason your external siren does not beep when you arm & disarm your Watchguard Digital, simply turn off the External Siren Key switch, wait for 10 seconds and then turn back on again. Now immediately (within 3 seconds) arm the system using your remote control. You should now hear 1 beep from the external siren.
27
