IronPort Systems 4108GL Note

6-6

Interface Access and System Information

Interface Access: Console/Serial Link, Web, and Inbound Telnet

Interface Access and

System Information

Reconfigure Web Browser Access. In the default configuration, web

browser access is enabled.

Syntax:[no] web-management

To disable web browser access:

To re-enable web browser access:

Reconfigure the Console/Serial Link Settings. You can reconfigure one

or more console parameters with one console command.

Syntax: console

[terminal <vt100 | ansi>]

[screen-refresh <1 | 3 | 5 | 10 | 20 | 30 | 45 | 60>]

[baud-rate

<speed-sense | 1200 | 2400 | 4800 | 9600 | 19200 |38400 | 57600>]

[flow-control <xon/xoff | none>]

[inactivity-timer <0 1 5 10 15 20 30 60 120>]

[events <none | all | non-info | critical | de bug]

Note If you change the Baud Rate or Flow Control settings for the switch, you

should make the corresponding changes in your console access device. Oth-

erwise, you may lose connectivity between the switch and your terminal

emulator due to differences between the terminal and switch settings for these

two parameters.

All console parameter changes except events require that you save the config-

uration with write memory and then execute boot before the new console

configuration will take effect.

For example, to use one command to configure the switch with the following:

■VT100 operation

■19,200 baud

■No flow control

■10-minute inactivity time

■Critical log events

you would use the following command sequence: