13-11
HP Procurve Stack Management
HP Procurve Stack Management
HP Procurve Stack
Management
Table 13-3. Stacking Configuration Guide
The easiest way to automatically create a stack is to:
1. Configure a switch as a Commander.
2. Configure IP addressing and a stack name on the Commander.
3. Set the Commander’s Auto Grab parameter to Yes.
4. Connect Candidate switches (in their factory default configuration) to
the network.
This approach automatically creates a stack of up to 16 switches (including
the Commander). However this replaces manual control with an automatic
process that may bring switches into the stack that you did not intend to
include. With the Commander’s Auto Grab parameter set to Yes, any switch
conforming to all four of the following factors automatically becomes a stack
Member:
■Default stacking configuration (Stack State set to Candidate, an d Auto Join
set to Yes)
■Same subnet (broadcast domain) and default VLAN as the
Commander (If VLANs are used in the stack environment, see
"Stacking Operation with a Tagged VLAN" on page 13-46.)
■No Manager password
■14 or fewer stack members at the moment
Join Method1Commander
(IP Addressing Required)
Candidate
(IP Addressing Optional)
Auto Grab Auto Join Passwords
Automatically add Candidate to Stack
(Causes the first 15 eligible, discovered
switches in the subnet to automatically
join a stack.)
Yes Yes (defaul t) No (default)*
Manually add Candidate to Stack
(Prevent automatic joining of switches
you don’t want in the stack)
No (default) Yes (defa ult) Optional*
Yes No Optional*
Yes Yes (defaul t) or No Configured
Prevent a switch from being a Candidate N/A Di sabled Optional
*The Commander’s Manager and Operator passwords propagate to the candidate when it joins the stack.