11-12
Optimizing Port Usage Through Traffic Control and Port Trunking
Port Trunking
Ports: Traffic Control
and Trunking
link is restored, that link is automatically included in the traffic distribution
again. The LACP option also offers a standby link capability, which enables
you to keep links in reserve for service if one or more of the original active
links fails. See “Trunk Group Operation Using LACP” on page 11-25.)
Trunk Configuration Methods
Dynamic LACP Trunk: The switch automatically negotiates trunked links
between LACP-configured ports on separate devices, and of fers one dynamic
trunk option: LACP. To configure the switch to initiate a dynamic LACP trunk
with another device, use the interface ethernet command in the CLI to set the
default LACP option to Active on the ports you want to use for the tr unk. For
example, the following command sets ports C1-C4 to LACP active:
HP4108(config) int e c1-c4 lacp active
Note that the above example works if the ports are not alrea dy operating in a
trunk. To change the LACP option on ports already operating as a trunk, you
must first remove them from the trunk. For example, if ports C1 - C4 were
LACP-active and operating in a trunk with another device, you would do the
following to change them to LACP-passive:
HP4108(config)# no int e c1-c4 lacp Removes the ports from
the trunk.
HP4108(config)# int e c1-c4 Configures LACP
lacp passive passive.
Static Trunk: The switch uses the links you configure with the Port/Trunk
Settings screen in the menu interface or the trunk command in the CLI to crea te
a static port trunk. The switch offers three types of static trun ks: LACP, Trunk,
and FEC.
Table 11-3. Trunk Types Used in Static and Dynamic Trunk Groups
Trunking
Method
LACP Trunk FE C
Dynamic Yes No No
Stat ic Yes Yes Ye s